S4 V8-4.2L (BHF) (2004)
Wiper Motor: Service and Repair
Rear Window Wiper Motor, Removing and Installing
Rear Window Wiper Motor, Removing And Installing
Removing
-
Remove wiper arm.
-
Remove lower rear lid trim.
-
Disconnect electrical connection - 2 -.
-
Disconnect washer fluid hose - 1 - from connecting pipe for spray jet.
-
Loosen nuts - arrows - and detach wiper motor.
Installing
Install in reverse order of removal, noting the following:
-
Carefully insert rubber grommet into hole in rear window.
-
Fluid hose must audibly engage in spray jet connection.
-
Switch on ignition.
-
Actuate rear wiper and allow wiper motor to move to end position.
CAUTION:
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
-
Install lower rear lid trim.
-
Adjust wiper arm.
Component - fastener
Nm
Wiper motor to rear lid - nut
8