S4 Quattro Cabriolet V8-4.2L (BHF) (2008)
/Page-1488002.png)
Installation is performed in reverse sequence. Note the following:
Note:
^
Replace seals and gaskets.
^
The drain plug with seal must be replaced.
-
Clean all magnets in recesses on oil pan. Make sure that magnets make full contact with oil pan.
-
Clean sealing surface thoroughly; remaining material from the previous gasket must be removed completely.
-
Tighten oil pan bolts in several stages and in diagonal sequence.
-
Tighten new drain plug - 1 -.
-
Fill with ATF Go To Draining ATF or filling after repairs See: Fluid - A/T/Service and Repair/09L, 6 Speed AWD A/T/Draining ATF or Filling
After Repairs.
Tightening torques
