S4 Quattro Cabriolet V8-4.2L (BHF) (2008)
Constant Velocity Joint: Overhaul
Triple Roller Joint Outer Constant Velocity Joint
Outer constant velocity joint, servicing
Outer CV joint, removing
-
Secure drive shaft with protective covers in vise clamp.
-
Remove clamp and slide boot back.
-
Screw Pressure Spindle 3207 with M 16/M14 thread version into joint pins until constant velocity joint is press off of drive axle.
-
Remove circlip
Outer CV joint, installing
-
Slide joint protective boot onto drive axle.
Protective boot and boot seat on drive axle must be free of grease.
-
Install new circlip
Circlip (snap ring) must be replaced.
-
Apply 50 g joint grease in inside of joint.
-
Before installing joint or triple roller star, splines - A - must be lightly coated with grease used in joint.