S4 Quattro Cabriolet V8-4.2L (BHF) (2008)
Shifter M/T: Procedures
Shift mechanism, adjusting - 6 Spd. Manual Transmission 0A3 All Wheel Drive
The following are prerequisites for correct gear lever alignment:
Note:
^
Shift linkage must be in proper condition and undamaged.
^
Shift mechanism must move freely.
^
Transmission, clutch and clutch mechanism must be in proper condition.
^
Transmission in neutral.
Procedure
-
Remove gear lever knob together with boot.
Vehicles with large radio slot
-
Remove operating and display unit for air conditioner.
Vehicles with small radio slot
-
First lift trim panel - 1 - in direction of - arrow A -, then pull it out in direction of - arrow B -.
Continued for all vehicles
-
Remove bolts - arrows C - and then pull ashtray - 2 - out of center console.
-
Disconnect electrical connector for ashtray light.
-
Remove foam wedges from center console.
-
Lift out the noise insulation.
-
Remove noise insulation for gear lever housing - arrows -.