S4 Quattro Sedan V6-2.7L Turbo (APB) (2000)
-
Screw in bolt from 2085/1 oil ring extractor.
-
Pull out seal with oil seal extractor 2085 and bolt 2085/1.
-
Clean contact surface and sealing surface.
Note: Do not apply oil to sealing lip or outer circumference of seal before installing.
-
Fit guide sleeve (from tool set 3241) onto camshaft.
-
Press in seal until flush using press sleeve 3241/1 and bolt 3241/3.
Installing
Install in reverse sequence.
Note: When installing Hall sender rotor, ensure that locating lug engages in slot in camshaft.
Rear oil seal and sealing flange (left cylinder head)