S4 Quattro Sedan V6-2.7L Turbo (APB) (2000)
Wheel Bearing: Service and Repair
Wheel Bearing Housing, Servicing
Wheel Bearing Housing, Servicing
1. Wheel bearing housing
Do not grease bearing seat in wheel bearing housing before pressing in wheel bearing
After replacing, check and if necessary adjust wheel alignment
2. Clamping sleeve
Always replace
Left and right sides identical
Grease all around with brake cylinder paste before inserting into wheel bearing housing
Press into wheel bearing housing until fully seated
3. ABS wheel speed sensor
To remove, pull out
Do not install until drive axle has been installed
To install, press in by hand until fully seated
4. Bonded rubber bushing
Replacing refer to Figs. 1, 2 and 3.
Always replace both bushing halves
5. Wheel bearing
Stepped design