S4 Quattro Sedan V6-2.7L Turbo (APB) (2000)
-
Specified value: approx.: 0 Ohm
-
Depress clutch pedal.
-
Specified value: infinity Ohms (no continuity)
If specifications are not obtained:
-
Replace clutch vacuum vent valve switch.
If specification is obtained:
Check voltage supply
-
Connect VAG1527 B between following sockets on harness connector:
Harness connector
Measure against
terminal
2
Ground (GND)
-
Switch ignition on.
-
The LED must come on
If LED does not come on:
-
Check wire connection from terminal 2 of connector for open circuit (fuse) or short circuit to Ground (GND).
-
If necessary eliminate open circuit or short circuit to Ground (GND)
If LED comes on:
Check activation
-
Connect VAG1598/31 test box to wiring harness for engine control module. Do not connect to the engine control module itself. Refer to "Scan
Tool Testing/Wiring And Component Check With VAG1598/31 Test Box", See: Testing and Inspection
Test the following wiring connections for open circuits and short to B+ or Ground (GND):
Harness connector
Measure against
terminal
1
39
-
Repair any open/short circuit as necessary.