S4 Quattro Sedan V6-2.7L Turbo (APB) (2000)
Rear lower anchors, installing
1
-
Rear lower anchor bracket
-
Remove rear seat.
-
Disconnect connectors
-
Remove bolts - 4 - (2x).
2
-
Bolts (4x)
-
30 Nm (22 ft.lb)
-
Mount rear lower anchor bar - 1 - with bolts - 2 - fastened into threaded holes in body floor panel.
NOTE:
-
To install solid rear backrest, push tabs behind rear lower anchor bracket.
-
If rear lower anchor is retrofitted, it may be necessary to flatten tab in vise down to about 3 mm.
-
Inside anchors are not recommended for attaching rear lower anchors of a LATCH seat in the middle position. The three-point
lap/shoulder belt should be used.