S4 Quattro Sedan V6-2.7L Turbo (APB) (2000)
Fuel Gauge Sender: Service and Repair
Sender For Fuel Gauge -G, Removing and Installing
Sender For Fuel Gauge -G, Removing and Installing
Removing
-
Fuel pump flange, removing.
-
Carefully lift out fuel pump flange with fuel supply line connected and set aside.
-
On the inside of the fuel pump flange disconnect connector for fuel gauge sender.
-
Remove sender by pressing tab -arrows-.
NOTE:
-
The fuel accumulator housing is shown in the illustration without the fuel tank.
-
The illustration shows the fuel gauge sender for vehicles with front wheel drive.
Installing
Installation is in reverse order of removal, but do the following:
-
Install sender for fuel gauge in guides of outer fuel accumulator housing and press down until locked in place.
Fuel pump flange, installing. Observe note regarding disconnecting battery.