S4 Quattro Sedan V6-2.7L Turbo (APB) (2000)
-
Unscrew both nuts -A-.
-
Lift E-box off studs at the rear and then pull it out of securing point -B-.
Note:
^
In the following procedures, make sure that no brake fluid escapes into the plenum chamber or onto the transmission below. If this does
happen, clean the affected areas thoroughly.
^
When performing work in the footwell, put cloths on the carpet to protect it from possible brake fluid spills.
-
Clamp supply hose -A- from brake fluid reservoir using special tool 3094. Pull hose off master cylinder and plug hose.
-
Remove rubber grommet for compensation hose above connecting line from transverse wall.
-
Pry out retaining clip -C- using a screwdriver and pull line -B- out slightly.