S4 Quattro Sedan V6-2.7L Turbo (APB) (2000)
![background image](/audi/s4_quattro_sedan/v6-2.7l_turbo_(apb)/Page-5198003.png)
-
Allow primer to air dry for approx. 10 minutes.
Fig. 2 Adhesive bead cross section
CAUTION: Note various spacing dimensions of adhesive bead to window edge.
1
-
Adhesive sealing material
2
-
Primer
3
-
Windshield
-
Dimension - a - = 8 mm
-
Dimension - b - = 12 mm
-
Dimension - c - at upper window edge and at side window edges = 8 mm
-
Dimension - c - at lower window edge = 13 mm
NOTE: If adhesive sealing material leaks out at lower window edge during installation, it must be removed immediately.
Fig. 3
-
Beginning at top, press cover strip - 1 - completely into retaining clips - 4 - at left and right.
2
-
Rear window
3
-
Adhesive bead
5
-
Hollow rivet
-
Further procedure steps should be derived from "Windshield, installing".