S4 Quattro Wagon V8-4.2L (BHF) (2008)
/Page-3712002.png)
‹› Tightening specification 5 Nm
2
Rear cross panel trim
‹› Removal:
-
Open luggage compartment floor lid.
-
Remove screws - 1 - (Qty. 4).
-
Carefully remove rear cross panel trim - 2 - from locking pins - arrows -.
‹› Installing:
To install, perform the steps used in removal in reverse order. Observe the following when doing so:
-
Tailgate rubber must lie over rear cross panel trim.
-
Tighten screws to 5 Nm.