S4 Quattro Wagon V8-4.2L (BHF) (2008)
-
Remove nut - 1 - and remove electrical wiring harness at rear coolant pipe.
-
Loosen hose clips - 1 - with the Hose Clip Pliers (VAS 6340).
-
Loosen hose clip - 6 - with the Hose Clips Pliers (VAS 6340) and remove the coolant hose.
-
Remove bolts - 2 to 5 -.
-
Remove rear coolant pipe.
Installing
Installation is in reverse order of removal, note the following:
‹› Replace O-rings.
‹› Secure all hose connections using hose clamps appropriate for the model type.
‹› During installation, all cable ties must be re-installed at the same location.
-
Clean and/or smooth O-rings sealing surface before installing.
-
Coat new O-rings with non-corrosive lubricant (Vaseline), install rear coolant pipe and tighten.
-
Install right coolant pipe. Refer to => [ Right Coolant Pipe ] See: Right Coolant Pipe.
-
Install lock carrier with attachments. Refer to =>
Radiator Support See: Body and Frame/Lock Carrier