S4 Quattro Wagon V8-4.2L (BHF) (2008)
/Page-3001004.png)
Replacement/Standard Front Seat, From November 2004
‹› Power seat: from November 2004, refer to => [ Backrest Cover ] See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Power Front Memory Seats, From November 2004
‹› Recaro Seat, from November 2004, refer to => [ Backrest Cover ] See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Recaro Front Seats, From November 2004
-
Pry off lower fastening strips - 9 - (Qty. 3) with a screwdriver.
-
Pry off side retainer strips - 1 - with a screwdriver and fold cover forward.
-
Cut upholstery clips - 10 - (Qty. 4) at protective cover for side airbag - 6 -.
-
Press latch - 3 - downward and disconnect electrical harness connector for side airbag - 2 -.
-
Remove screw - 7 -.
-
Drill out rivet - 5 -.
-
Lift side airbag - 4 - upward and remove it.
‹› Installing
To install, perform the steps used in removal in reverse order. When doing so, note the following:
-
Engage side airbag - 4 - into backrest frame.
-
Press side airbag - 4 - downward until it stops.
-
Place eye of Ground (GND) cable - 11 - between backrest frame and side airbag - 4 -.
-
Secure ground cable - 11 - with a rivet.
-
Replace screw - 7 -.
-
Bolt side airbag - 4 - on with bolt - 7 -.
-
Make sure that airbag cable - 13 - runs through cable guide - 14 - and is secured by clip - 12 - to backrest frame.
-
Use upholstery clip pliers (V.A.G 1634) to install new upholstery clips on protective cover for side airbag.
-
Switch on ignition.
CAUTION!
No one should be in vehicle when connecting battery.
-
Connect the battery ground (GND) strap.
‹› Follow safety measures after connecting battery.
‹› If the Airbag Malfunction Indicator Lamp (MIL) ( K75) shows a malfunction after assembly, DTC memory must be checked with Vehicle
Diagnostic, Testing and Information System ( VAS 5051 A), cleared and then rechecked.
5
Rivet
6
Side Airbag Protective Cover
7
Bolt
‹› Tightening specification 10 Nm
‹› Replace after each disassembly
8
Front seat