S4 Quattro Wagon V8-4.2L (BHF) (2008)
Installation is reverse of removal, paying attention to the following:
-
Observe notes for central venting of battery.
With ignition switched off and electrical consumers switched off, connect battery in the following sequence:
-
Connect terminal clamp of positive cable on battery positive terminal " +" by hand and tighten nut - 2 -.
-
Connect terminal clamp of Ground (GND) wire to battery negative terminal "-" by hand and tighten nut - 1 -.
-
Check battery for proper seating after installation.
‹› When reconnecting the battery, remember to activate vehicle equipment (radio/radio navigation system, clock, electric window, ) in accordance
with owner's manual.
‹› Deactivate service mode of Telematic Control Module. Guided Fault Finding; Adaptation; Telephone/Telematics
‹› After reconnecting voltage supply, ABS Malfunction Indicator Lamp (MIL) only goes out after driving several meters.
Tightening Specifications
Battery Central Gas Venting
CAUTION!