S4 Quattro Wagon V8-4.2L (BHF) (2008)
Fuse Block: Service and Repair
Coupling Station, Left A-Pillar Trim
Coupling Station, Left A-Pillar Trim
Removing
Component location: on the A-pillar, inside the left footwell
-
Switch off ignition and remove ignition key.
-
Remove the lower A-pillar trim.
-
Press clip in - direction of arrow - and disengage coupling station on A-pillar.
-
Unclip fuse panels from coupling station.
-
Remove relay or control modules, then unclip respective relay carrier.
‹› Check the exact connector station assignment in the current wiring diagram Wiring diagrams, Troubleshooting & Component locations.
Installing
Install in reverse order of removal, observing the following:
-
Install the lower A-pillar trim.