S4 Quattro Wagon V8-4.2L (BHF) (2008)
-
If installed, unbolt heat shield for drive shaft (left-side) - 1 -.
-
Unscrew nut - 1 - and pull selector shaft lever - 2 - off transmission selector shaft.
-
Unscrew connecting rod - 2 - for selector rod.
-
Disconnect push rod - 1 -; to do so, unscrew hexagon socket head bolt.
-
Remove selector mechanism from right side of vehicle.
Installing
Installation is performed in reverse sequence; note the following:
Note:
^
Always replace seals, gaskets and self-locking nuts.
-
Install tunnel cross member.
-
Bolt driveshaft onto transmission.
-
Install exhaust system and perform stress-free alignment.
-
If installed, install rear noise insulation.
-
Adjust selector mechanism.
-
Install operating and display unit for air conditioner.
Tightening torques