S5 Quattro Coupe V8-4.2L (CAUA) (2009)
-
Remove the bolts - 1 - on the lower bumper cover section.
-
Loosen the bumper cover locking mechanism - 3 - by turning the clamping bolt counter-clockwise.
-
Remove the left and right bolts - 1 - on the bumper side walls.
-
Disengage the left and right bumper side walls on the side panel - arrow -.
-
Remove the bumper cover - 2 -. The parking aid sensor electrical wire must be guided out through the body opening.
-
Free up the electrical wiring harness spiral clip.
‹› Use a soapy solution if necessary make removal easier.
Installation
‹› Gap dimensions, refer to => [ Rear Bumper Cover Gap Dimensions ] .
‹› Tightening specifications, refer to => [ Rear Bumper Cover Assembly Overview ] See: Service and Repair.
Installation is reverse of removal, but note the following:
-
Connect the electrical connector on the parking aid control module (J446) if applicable.
-
Install the tail lamps.