S5 Quattro Coupe V8-4.2L (CAUA) (2009)
Power Seat Switch: Service and Repair
Lumbar Support Adjustment Switch
Manual Standard Front Seats
Lumbar Support Adjustment Switch
Removing
CAUTION!
‹› Follow the safety precautions for pyrotechnic components.
‹› Before handling pyrotechnic components (e.g. disconnecting the electrical connector), the person handling it must "discharge static
electricity ". This can be done by touching door striker, for example.
-
Remove tunnel side trim panel => [ Trim, Sill Side ]. See: Seats/Service and Repair/Removal and Replacement/Manual Standard Front Seats
-
Disconnect connector - 4 -.
-
Remove the bolts - 2 -.
-
Remove the lumbar support adjustment switch (E176) or (E177) - item 1 - from the trim - 3 -.
Installing
CAUTION!
‹› Follow the safety precautions for pyrotechnic components.
‹› Before handling pyrotechnic components (e.g. connecting the electrical connector), the person handling it must "discharge static
electricity ". This can be done by touching door striker, for example.
Installation is reverse of removal, but note the following:
-
Route the wires as close to the connector - 4 - as possible.