S5 Quattro Coupe V8-4.2L (CAUA) (2009)
/Page-496002.png)
-
Lubricate the seal remover threaded head, position it, and install it in the shaft seal for the A/C compressor drive and power steering pump drive as
far as possible using strong force.
-
Rotate the inner section of the seal puller against the spur gear unit until the shaft seal is removed.
‹› If the shaft seal breaks, position the seal puller a second time and remove the rest of the seal.
-
Clamp seal puller in a vise at the hex bolt and remove the shaft seal with pliers.
-
Clean running and sealing surface.
-
Drive A/C compressor drive shaft seal in as far as the stop using the Thrust Piece (T40192).
-
Drive the power steering pump drive shaft seal in as far as the stop using the Thrust Piece (T40193).
