S5 Quattro Coupe V8-4.2L (CAUA) (2009)
‹› The trim piece - B - is supplied with a two-sided adhesive strip already installed - C -.
‹› If the trim piece - B - is going to be re-used when replacing the Climatronic Control Module (J255) - A -, A/C control head, the remove the
adhesive strip - C - from the trim - B -. Clean the adhesive surface on the trim - B - as described in the instructions which came with the adhesive
strip. Affix to the trim piece - B - a strip (dimension: 204 mm x 10 mm) of the two-sided adhesive strip - C - with material strength approximately
1.2 mm (for example with adhesive tape D 438 515 A1.
‹› At the start of production, this trim - B - is secured by clips - C - into the openings in the - D - Climatronic Control Module (J255) - A -, A/C
control head. Later, the trim piece - B - was redesigned so that it can be secured by a suitable two-sided adhesive tape. The retaining tabs - F - are
no longer on the trim piece - B -.
‹› Since the openings - D - and slits - E - are no longer being used, only the trim piece - B - with the two-sided adhesive tape for the Climatronic
Control Module (J255) - A -, A/C control head, is supplied as a replacement part.
‹› Climatronic Control Module (J255) allocation. Refer to => [ A/C Control Modules ] See: Description and Operation/A/C System Control.
‹› A/C Control Head, Removing and Installing. Refer to => [ A/C Control Head Module ] See: Service and Repair/Removal and Replacement/A/C