S5 Quattro Coupe V8-4.2L (CAUA) (2009)
Alignment: Service and Repair
Front Axle Camber, Checking and Adjusting
Front Axle Camber, Checking and Adjusting
Camber cannot be adjusted.
By moving subframe, it is possible to center camber evenly within the specified/tolerance range.
-
Remove noise insulation.
‹› The tunnel crossmember must be loosened before adjusting the camber.
‹› The tunnel crossmember must be loosened to prevent the transmission mount from being stressed.
-
Loosen bolts - 1 - through - 8 -.
Depending on engine version, the following steps are necessary to loosen the bolt - 1 -.
‹› Remove right protective joint boot, if applicable.
‹› Remove one wheel housing liner clip.
‹› Tilt wheel housing liner to side slightly.
‹› If the subframe is moved, the front of the vehicle must be lifted at the jack points using an axle lift.
-
Using a plastic-coated tire iron, slide subframe with engine mount and stabilizer bar in appropriate location.