S5 Quattro Coupe V8-4.2L (CAUA) (2009)
![background image](/audi/s5_quattro_coupe/v8-4.2l_(caua)/Page-793002.png)
Checking internal resistance
-
Using a multimeter, check the Engine Speed (RPM) Sensor (G28) terminals 2 to 3 for resistance.
Specified value: 0.7 to 1000 kohms
-
Check Engine Speed (RPM) Sensor (G28) terminals 1 to 2 and 1 to 3 for short circuits.
Specified value: infinite (infinity)
If any of the specified values are not obtained:
-
Replace the Engine Speed (RPM) Sensor (G28).
If the specified values are obtained:
Checking wiring
If the manufacturers test box is being used, perform the following step.
-
Install the test box.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module, Replacing ] See: Engine Control
Module/Service and Repair/Engine Control Module, Replacing.
-
Using a Multimeter, check the Engine Speed (RPM) Sensor (G28) electrical harness connector terminals to the Motronic Engine Control Module
(ECM) (J623) electrical harness connector T60 terminals for resistance.