S5 Quattro Coupe V8-4.2L (CAUA) (2009)
sensor must be connected with crimp connectors.
Removing
CAUTION!
‹› Follow the safety precautions for pyrotechnic components and seat occupied recognition system passenger airbag deactivation => [
Passive Occupant Detection Sensor Additional Safety Precautions ] See: Seat Occupant Sensor/Service Precautions.
‹› Before handling pyrotechnic components (e.g. disconnecting the electrical connector), the person handling it must "discharge static
electricity ". This can be done by touching door striker, for example.
-
Remove front seat:
‹› Standard seat and sport seat (manual), refer to => [ Manual Standard Front Seats ] See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Manual Standard Front Seats.
‹› Standard seat, sport seat (power) and comfort seat, refer to => [ Power Standard Front Seats ] See: Body and Frame/Seats/Service and
Repair/Removal and Replacement/Power Standard Front Seat with or without Memory Function.
‹› Super sport seat, refer to => [ Super Sport Front Seats ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Power Super
Sport Front Seat with or without Memory Function.
-
Attach front seat to Fixture For Seat Repair (VAS 6136), refer to => [ Front Seat, Installing on VAS 6136 ] See: Body and Frame/Seats/Service
and Repair/Removal and Replacement/Seat Versions Overview.
-
Remove the bolt - 3 - and the seat position sensor - 4 - from the seat pan lower frame.
CAUTION!
Do not damage the insulation on the individual wires.
-
Cut the protective hose - 2 - back just in front of the clip - 1 -.
-
Cut through both electrical wires at the places marked with - arrow A - and - arrow B - to approximately 1 /3 to 2/3 of the free length.
Installing
CAUTION!
‹› Follow the safety precautions for pyrotechnic components.
‹› Before handling pyrotechnic components (e.g. connecting the electrical connector), the person handling it must "discharge static
electricity ". This can be done by touching door striker, for example.
-
Cut the electrical wires on the new seat position sensor to the same length as those on the old sensor.
‹› The same wire colors must have the same length.
-
Connect the electrical wires with crimp connectors - arrow A - and - arrow B -.