S5 Quattro Coupe V8-4.2L (CAUA) (2009)
/Page-1607002.png)
-
Connect wiring harness connectors - 3 - to control module - 8 -.
-
Carefully slide wiring harness clip connection - 3 - into bracket - 4 -.
-
Insert control module with bracket.
-
Connect ground (GND) wire - 2 - to the threaded pin and tighten nuts - 1 - to 6 Nm.
-
Tighten nuts - 7 - to 6 Nm.
-
The system must be calibrated if active steering control module is replaced (J792) => [ Dynamic Steering Calibration Procedure ] See:
Steering/Testing and Inspection/Programming and Relearning.
Tightening specifications
