S5 Quattro Coupe V8-4.2L (CAUA) (2009)
-
Remove bolt - 1 -.
-
Remove booth joint pins in upper control arm - 2 - from wheel bearing housing.
The slits in wheel bearing housing must not be widened using a chisel or similar tool!
-
Loosen wheel bearing housing from drive axle splines and remove it.
‹› Drive axle must not hang down, otherwise inner joint may be damaged when bent too far.
‹› Secure drive axle to body using wire.
Installing
Installation is in reverse order of removal. Observe the following when doing so:
Tightening specifications: => [ Wheel Bearing and Housing Assembly Overview ] See: Wheel Bearing and Housing Assembly Overview.