S5 Quattro Coupe V8-4.2L (CAUA) (2009)
Install in reverse sequence; note the following points:
‹› Check SAC pressure plate for distortion before installing again => [ SAC Pressure Plate, Checking for Distortion,
Cracks and Burn Marks ] See: Pressure Plate/Service and Repair/SAC Pressure Plate with Single Disc Clutch Assembly Overview
‹› If only replacing SAC clutch plate, the adjusting ring must be turned back before installation => [ SAC Pressure Plate with Single Disc Clutch,
Adjusting Ring Resetting ] See: Pressure Plate/Adjustments.
-
Center the clutch disc using the thrust piece (T40171).
‹› Clutch plate installation location: Spring pack (coil springs) or marking " Getriebeseite" must face pressure plate and transmission.
-
Press pressure plate on alignment pin.
-
Position the clutch module so the thrust pad (VW 510) rests on the support ring - arrow A - in the dual mass flywheel.