S5 Quattro Coupe V8-4.2L (CAUA) (2009)
Clutch Disc: Service and Repair
SAC Pressure Plate with Two-Disc Clutch
SAC Pressure Plate with Two-Disc Clutch
Special tools, testers and auxiliary items required
‹› Pressure plate (VW 402)
‹› Punch (VW 412)
‹› Thrust pad (VW 510)
‹› Alignment fixture (T10254/3)
‹› Thrust piece (T40089/2)
Removing
‹› The clutch module is removed => [ Clutch Module ] See: Service and Repair/Removal and Replacement/Clutch Module.
CAUTION!
The pressure plate and the dual mass flywheel could be damaged.
‹› Only remove and install the pressure plate - 1 - when it is pre-tensioned.
‹› Pressure plates that are not pre-tensioned will distort when loosening or tightening the bolts - 2 - and that leads to shuddering when
accelerating.
‹› The dual mass flywheel - 1 - must only be supported by the support ring - arrow A - when tensioning the pressure plate - 3 - in the hydraulic
press.
‹› If the dual mass flywheel is supported on the transfer plate - arrow B -, it will distort and be damaged. The dual mass flywheel must then
be replaced.