S5 Quattro Coupe V8-4.2L (CAUA) (2009)
‹› Observe work sequence when bleeding => [ Clutch System Bleeding ] See: Clutch Hydraulic System/Service and Repair/Procedures/Clutch
System Bleeding.
‹› When inserting, push in so far until the bolt can be installed.
10
Transmission
Checking the Release Bearing through 02.08
‹› Release bearing with loosened plastic ring - 1 - must be replaced.
‹› If the running surface - arrow 2 - on plastic ring - 1 - is worn deeper than 0.8 mm, the release bearing - 3 - must be replaced.
Swash Plate Clutch Release Bearing, from 02.08, Checking
‹› The plastic pressure ring for the release bearing - 1 - may have axial and radial play.
‹› The plastic ring - 1 - can tip on all sides inside the release bearing - 3 -.
‹› If the running surface - arrow 2 - on plastic pressure ring - 1 - is worn deeper than 0.8 mm, the release bearing - 3 - must be replaced.