S5 Quattro Coupe V8-4.2L (CAUA) (2009)
Seals and Gaskets: Service and Repair
Flange and Driveshaft Seal, Final Drive Removed
Flange and Driveshaft Seal, Final Drive Removed
Special tools, testers and auxiliary items required
‹› Puller (VW 391)
‹› Adapter (VW 771/40) from the Slide Hammer - Complete Set (VW 771)
‹› Retainer (3028)
‹› Pulling Hook (T20143)
‹› Driver (T40109)
‹› Sealing Grease (G 052 128 A1)
‹› 2 bolts M 8 x 30
‹› 1 bolt M 8 x 45
Removing
‹› The flange/driveshaft seal can replaced only when the final drive is removed.
Refer to general repair instructions. Refer to => [ General Repair Information ] See: Service and Repair/Procedures/Rear Final Drive 0BC
(0B4A,0B2A,0B6A,0B5A Transmission)/General Repair Information.
-
Remove rear final drive. Refer to => [ Rear Final Drive ] See: Service and Repair/Removal and Replacement/Rear Final Drive 0BC
(0B4A,0B2A,0B6A,0B5A Transmission)/Rear Final Drive.
-
Remove circlip - arrow -.
CAUTION!
Replace the circlip with a new one of the same thickness if it is stretched or damaged.
-
Mark the position of the flange/driveshaft - B - to the drive pinion - A - - arrow -.