S5 Quattro Coupe V8-4.2L (CAUA) (2009)
-
Clean the threads on the drive pinion.
Installing
Installation is performed in the reverse order of removal. Pay attention to the following:
-
Coat outer edge of the seal with axle oil.
-
Fill area between sealing lip and dust lip halfway with sealing grease (G 052 128 A1).
-
Drive in new shaft seal as far as stop without tilting it.
-
Warm the flange/driveshaft to approximately 176 °F (80 °C) using an inductive heater (VAS 6414)