S5 Quattro Coupe V8-4.2L (CAUA) (2009)
-
First tighten the bolt next to the colored marking - 1 - to 20 Nm.
‹› By doing this, the CV joint is pushed slightly to the opposite side and imbalance is avoided.
-
Then tighten the rest of the driveshaft bolts - 1 - on the rear final drive in stages to 20 Nm.
-
Tighten the 6 bolts to the tightening specification => [ (Item 5) Bolt ] See: Driveshaft Assembly Overview.
‹› Use the Counterhold Tool (T10172) with the Adapters (T10172/5) to do this.
-
Tighten the bolts on the front driveshaft. Tightening specification => [ (Item 5) Bolt ] See: Driveshaft Assembly Overview.
-
Remove Alignment Fixture (3139).
-
Tighten the driveshaft center bearing on the body without tension. Tightening specification => [ (Item 8) Bolt ] See: Driveshaft Assembly
Overview.
-
Attach the heat shield - A - to the transmission - arrows -, if applicable. Tightening specification