S5 Quattro Coupe V8-4.2L (CAUA) (2009)
Driveshaft tightening sequence:
-
First tighten the bolt next to the colored marking - 1 - to 20 Nm.
‹› By doing this, the CV joint is pushed slightly to the opposite side and imbalance is avoided.
-
Then tighten the rest of the driveshaft bolts - 1 - on the rear final drive in stages to 20 Nm.
-
Tighten the 6 bolts to the tightening specification => [ (Item 5) Bolt ] See: Driveshaft Assembly Overview.
‹› Use the Counterhold Tool (T10172) with the Adapters (T10172/5) to do this.
-
Install rear section of exhaust system.