S5 Quattro Coupe V8-4.2L (CAUA) (2009)
-
Insert sealing ring in groove on shaft.
-
Slide on CV joint up to sealing ring.
-
Align sealing ring at center with opening upward - see arrows -.
-
Install old axle shaft bolt into joint as shown in the illustration.
-
Drive joint onto axle shaft with plastic hammer until circlip engages.
-
Add specified quantity of grease to inner joint. See table => [ Grease Quantity and Type ] See: Service and Repair/Removal and
Replacement/Front Suspension/Drive Axle Assembly Overview.
-
Slide protective boot onto joint.
-
Bleed protective joint boot.
-
Make sure protective boot is seated on joint correctly.
-
Protective joint boot must fit in groove and on joint contour.
-
Tension clamps on outer joint => [ Large and Small Clamps, Clamping on Inner or Outer Joint ] See: Service and Repair/Procedures.