S5 Quattro Coupe V8-4.2L (CAUA) (2009)
‹› 10 Nm
9
Bolt
‹› 200 Nm + an additional 180° turn
‹› Replace after each removal => [ Drive Axle General Information ] See: Description and Operation/Front Suspension.
‹› Before installing, threads in constant velocity joint should be cleaned with a tap.
10
Wheel hub
‹› Removing and installing => [ Wheel Bearing ] See: Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service and
Repair/Overhaul/Front Suspension/Wheel Bearing.
11
Wheel bearing
‹› Removing and installing => [ Wheel Bearing ] See: Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service and
Repair/Overhaul/Front Suspension/Wheel Bearing.
CAUTION!
‹› Avoid contaminating with dirt and damaging the seal when setting down/storing => [ Avoid Contaminating with Dirt and Damaging
the Seal When Setting Down/Storing. ]
12
Bolt
‹› 40 Nm
‹› Always replace after removal
13
Nut
‹› 110 Nm
‹› Always replace after removal
‹› After loosening threaded connection of guide control arm to wheel bearing housing, adhesive residue must be removed on thread of linkage
stub.
14
Track control arm
15
Nut
‹› 110 Nm
‹› Always replace after removal
‹› After loosening threaded connection of track control arm to wheel bearing housing, adhesive residue must be removed on thread of linkage
stub.
16
Guide link
17
Tie rod end
18
Nut
‹› 20 Nm + an additional 90° turn
‹› Always replace after removal
19
Bolt
‹› 9 Nm
20
Wheel speed sensor