S5 Quattro Coupe V8-4.2L (CAUA) (2009)
Seals and Gaskets: Service and Repair
Input Shaft Seal, from Transmission Series Number 000761
Input Shaft Seal, from Transmission Series Number 000761
Special tools, testers and auxiliary items required
‹› Pulling hook (T20143/1)
‹› Thrust piece (T40174)
‹› Sealing grease (G 052 128 A1)
-
Transmission, removing => [ Transmission, Removing ] See: Service and Repair/Removal and Replacement/Transmission, Removing.
-
Remove the clutch module => [ Clutch Module ] See: Clutch/Service and Repair/Removal and Replacement/Clutch Module.
-
Pry the input shaft seal out.
-
Lightly oil new seal on outer circumference.
-
Fill area between sealing lip and dust lip halfway with sealing grease (G 052 128 A1).
-
Drive new seal in as far as the stop; be sure not to distort it.
-
Install the clutch module => [ Clutch Module ] See: Clutch/Service and Repair/Removal and Replacement/Clutch Module.