S5 Quattro Coupe V8-4.2L (CAUA) (2009)
‹› Ignore - item 2 -.
-
Position the puller (T40160) and remove the selector rod - 1 -.
-
Remove the exhaust system heat shield below the shift mechanism.
-
Remove the shift mechanism downward.
Installing
Install in reverse sequence; note the following points:
Tightening specifications:
=> [ Selector Mechanism Assembly Overview ] See: Selector Mechanism Assembly Overview
=> [ Shift Knob and Boot Assembly Overview ] See: Shift Knob and Boot Assembly Overview
‹› Seals and self locking nuts must be replaced.
-
Install tunnel crossmember.
-
Tighten the driveshaft on the transmission.
-
Reconnect exhaust system and ensure it is not under stress.
-
Install the rear noise insulation.
-
Adjust the selector mechanism => [ Shift Mechanism, Adjusting ] See: Adjustments.