S6 V8-4.2L (BBD) (2004)
^
Put in suspension strut so that hole (arrow) in spring seat faces middle of vehicle.
^
Bolt suspension strut together with track control link.
Note: Remove any adhesive remaining on thread of joint bolt.
^
Bonded rubber bushings can only be turned to a limited extent The suspension strut1track control link bolt connection should only be tightened
when vehicle is standing on ground.
^
Tighten new nuts to 90 Nm.
^
Insert upper links in wheel bearing housing and tighten new nuts -2- to 40 Nm.
^
Press upper links down as far as possible when tightening!
^
Tighten nut on joint bolt to 100 Nm.
Use 4 mm socket wrench to hold joint bolt if necessary.
^
Insert cable of ABS wheel speed sensor into bracket on brake caliper.
^
Screw on new bolts for suspension strut and tighten to 20 Nm.
Be careful not to damage surface of brake lines!
^
Put rubber grommets in plenum.
^
Mount wheel and tighten to 120 Nm.