S6 V8-4.2L (BBD) (2004)
Torque Converter: Service and Repair
Torque Converter, Installing
5 SPD. A/T 01L AWD
Torque converter, installing
^
Insert torque converter through seal to first stop on transmission shaft.
^
Push converter by hand into bell housing while turning converter until notches on converter hub engage with corresponding driver notches of
pump wheel and converter slides noticeably toward inside.
Installing dimension
The torque converter was correctly installed when the distance between the flange of the bell housing and the threaded plates at the converter is
approximately 22 mm.
If the converter was not properly installed, this dimension is approximately 10 mm.
CAUTION: If the torque converter was Installed Incorrectly, the hub notches and the driver notches of the ATF-pump will be damaged when the
transmission Is Installed,