S6 V8-4.2L (BBD) (2004)
Wiring Harness: Service and Repair
5 Speed Automatic 01V
5 SPD. A/T 01V
Wiring harness in transmission, removing and installing
Removing
^
Remove valve body.
^
Using a small screwdriver, pry out retaining tabs on solenoid valve connector and pull off harness connectors -A- one after the other.
^
Disengage wiring harness from retainers -13- on side of valve body.
Only for transmissions with hydraulic control E17
^
Turn valve body over, and disconnect connector from sensor for transmission RPM -1-.
^
Remove retaining clip (arrow -A-) and unclip wiring harness from retaining clip (arrow -B-).
^
Disconnect connector -2- from solenoid valve 4 -N91-.
Only for transmissions with hydraulic control E18/2