S6 Wagon L5-2226cc 2.22L DOHC Turbo (AAN) (1995)
Heated Oxygen Sensor: Testing and Inspection
Checking HO2S Control Signal
Heated Oxygen Sensor Connector
-
Disconnect harness connector -1- for HO2S signal wire.
-
Switch DVOM to 2 Volt (DC) measuring range.
-
Connect DVOM (using adapter cables from connector test kit VW 1594) between: ECM harness connector and engine GND.
-
Switch ignition ON.
^
Must be 450 (+/-) 50mV.
If NOT:
-
Connect VAG 1598 Test Box (using VAG 1598/5 adapter cable) to ECM harness connector. Refer to VAG 1598 Pin Out Box Connecting.
See: Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Scan Tool Testing/Scan Tool Connecting and
Initial Checks/Connecting and Testing VAG 1598 Pin Out Box
^
ECM harness connector at component is not connected.
-
Switch DVOM to resistance range.
Engine Control Module Harness Connector
-
Check continuity between harness connector in engine compartment and Test Box terminal 28 using wiring diagram.
^
Must be 1.0 ohm maximum.
If circuit is open:
-
Repair as necessary.
If circuit is NOT open:
-
Check continuity of GND connection between engine cylinder block and Test Box terminal 10 using wiring diagram.
^
Must be 1.0 ohm maximum.
If circuit is open:
-
Repair as necessary.
If there is no malfunction in wiring:
-
Replace ECM.