S6 Wagon L5-2226cc 2.22L DOHC Turbo (AAN) (1995)
Seals and Gaskets: Service and Repair
Center Differential Seal
NOTE: Transmission installed
-
Remove driveshaft, refer to Replacement.
-
Remove mounting screw for flanged shaft (arrow).
To loosen the mounting screw, screw two bolts in the flanged shaft and counter-hold with assembly lever.
-
Place oil drip tray below transmission.
-
Remove flanged shaft.
-
Pry out oil seal for flanged shaft with assembly lever.
-
Pack space between sealing lips of new oil seal with multipurpose grease.
-
Drive in seal as far as stop.
-
Install flanged shaft.
Tighten Flanged shaft to transmission to: 25 Nm (18 ft lb)
-
Check gear oil in final drive, refer to Checking/Filling Differential (Final Drive) Oil.
-
Install driveshaft.
-
Adjust driveshaft.