S8 Quattro Sedan V10-5.2L (BSM) (2009)
Humidity Sensor: Service and Repair
Humidity Sensor, Without Lane Assist
Switches
Humidity Sensor, without Lane Assist
Special tools, testers and auxiliary items required
‹› Improvised tool
-
Use 0.7 mm thick metal strip to make improvised tool with dimensions shown.
Removing
-
If the humidity sensor (G355) was replaced, select the "Replace" function for the respective control module in "Guided Fault Finding" or "Guided
Functions".
-
Remove front interior light: Through 08.07. Refer to=> [ Front Interior Lamp with Roof Electronics Control Module, through 08.07 ] See:
Lighting and Horns/Dome Lamp/Service and Repair/Front Interior Lamp with Roof Electronics Control Module, through 08.07, from 09.07 => [
Front Interior Lamp with Roof Electronics Control Module, from 09.07 ] See: Lighting and Horns/Dome Lamp/Service and Repair/Front Interior
Lamp with Roof Electronics Control Module, from 09.07
-
Remove interior mirror.
-
Remove screws - arrows -.
-
Unclip cover for sun visor center support and remove bolts.
-
Remove the sun visor center support.
-
Guide offset end of improvised tool - 1 - under side of trim - 2 - as shown.