S8 Quattro Sedan V10-5.2L (BSM) (2009)
1. Power steering pump
2. Seal
3. Input shaft
-
Install the pressure line and banjo bolt - 2 - to the pump. Refer to - item 6 - in => [ Power Steering Pump Assembly Overview ] See: Steering and
Suspension/Steering/Service and Repair/Removal and Replacement/Power Steering Components.
-
Tighten the bolts - 4 -. Refer to - item 3 - in => [ Power Steering Pump Assembly Overview ] See: Steering and Suspension/Steering/Service and
Repair/Removal and Replacement/Power Steering Components.
-
Tighten the bolt - 3 -. Refer to - item 6 - in => [ Power Steering Pump Assembly Overview ] See: Steering and Suspension/Steering/Service and
Repair/Removal and Replacement/Power Steering Components.
-
Install the suction hose - 1 - to the pump and secure with the clamp.
-
Top off the hydraulic fluid.
Suction hose, location on power steering pump. Refer to => [ Suction and Return Hoses, Installed Position ].
-
Clean any hydraulic fluid from areas on the subframe.
-
Install the drive axle. Refer to => [ Drive Axle ] See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service
and Repair/Removal and Replacement/Front Suspension/Drive Axle.
-
Install the left catalytic converter.
-
Install the engine.