S8 Quattro Sedan V10-5.2L (BSM) (2009)
Collision Avoidance Module: Service and Repair
Lane Change Assistance Control Modules
Removing
-
Remove rear bumper cover.
-
Disconnect electrical connector - 3 -.
-
Remove bolts - 2 - and - 4 -.
-
Remove the lane change assist control module - 1 - from the mount on the bumper - arrow -.
Installing
Install in reverse order of removal, observing the following:
-
Install rear bumper cover.
Lane Change Assistance Control Module (J769)/ (J770) must be re-calibrated each time bumper cover is removed. Refer to=> [ Lane Change
Assistance, Preparing for Calibration ] See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Testing and
Inspection/Lane Change Assistance, Preparing for Calibration.