S8 Quattro Sedan V8-4.2L (AYS) (2002)
-
Check wiring connection from socket 2 of particular connector of engine mount for short to Ground.
If diode test lamp does not blink.
Checking wiring connection
-
Connect VAG1598/31 test box to wiring harness for engine control module. Do not connect to the engine control module itself. Refer to "Scan
Tool Testing/Scan Tool Connecting and Initial Checks/Connecting VAG1598/31 Test Box" under "Powertrain Management" See: Powertrain
Management/Computers and Control Systems/Testing and Inspection
-
Check wiring connection of particular connector of engine mount for open circuit and short circuit to B+.
2-pin harness connector, terminal VAG1598/31 test box, socket
2
105
2
116
Wiring resistance: max. 1.5 ohm
-
Eliminate short or open circuit if necessary.
If there is no malfunction in the wiring:
-
Replace particular engine mount.
-
Display readiness code.
If DTC memory was erased generate readiness code.
Refer to "Monitors, Trips and/or Drive Cycle (Readiness Codes)/Checking Readiness Code" under "Powertrain Management" See: Powertrain
Management/Computers and Control Systems/Testing and Inspection
Refer to "Monitors, Trips and/or Drive Cycle (Readiness Codes)/Generating Readiness Code" under "Powertrain Management" See: Powertrain
Management/Computers and Control Systems/Testing and Inspection