S8 Quattro Sedan V8-4.2L (AYS) (2002)
/Page-255002.png)
Tighten both rear subframe bolts.
Removing special tool VAG 1926
^
At least two bolts must always be tightened so that the position of the sub-frame does not change!
^
Replace front subframe bolts with washers.
^
Replace rear subframe bolts with washers.
^
Toe-in must always be checked when camber has been corrected.
Extending springs on vehicles with standard suspension
^
Insert spacer gauge VAG 1925 with adapters VAG 1925/2 and screw both threaded stems out until they make contact with the front subframe bolts
-1-.
Standard suspension
^
The alignment program now checks if the current toe-in value corresponds to the specified value
^
If necessary use tie rods to adjust toe-in.
Extending springs on vehicles with sports suspension
^
Position axle lift under front jacking points and raise vehicle.
^
Insert adapter VAG 1925/5 onto adapters VAG 1925/2 of spacer gauge.
^
Lower vehicle.
Note: Sports suspension
^
The alignment program now checks if the current toe-in value corresponds to the specified value.
^
If necessary use tie rods to adjust toe-in.
^
For the next work sequence it must be ensured that the wheels do not lose contact with the turn-tables during the lifting operation!
^
If this happens it must be ensured that the turn tables do not move as this will give false results!
^
Position axle lift under front jacking points and raise vehicle.