S8 Quattro Sedan V8-4.2L (AYS) (2002)
Installing
^
Tightening torque of ball screws -1-: 80 Nm (59 ft. lbs.) plus additional 90° turn.
^
Slide drive axle outer joint pin into wheel hub and tighten new hex bolt hand tight.
Any residual adhesive on threads of joint bolt should be removed.
^
Install both upper link joint pins into wheel bearing housing.
^
Install new self-locking nuts -1- and tighten to 40 Nm (30 ft. lbs.)
^
When tightening press upper link as far downward as possible!
^
Install ABS speed sensor.
^
Install brake disc, bolt on brake caliper and tighten to 190 Nm (140 ft. lbs.).
^
Install wheel and tighten to 120 Nm (89 ft. lbs.).
^
Tighten drive axle hex bolt. Only tighten with vehicle standing on its wheels -danger of accident-.
Tightening torque (hex bolt): 190 Nm (140 ft. lbs.) plus additional 180° turn.
The alignment of the front suspension must be checked and if necessary adjusted using VW/Audi-approved wheel alignment equipment.