S8 Quattro Sedan V8-4.2L (AYS) (2002)
^
Slide drive shaft back to stop together with alignment fixture.
^
Mark position of center bearing on body (arrow -A-).
^
Slide drive shaft forward together with alignment fixture.
^
Mark position of center bearing on body (arrow -B-).
^
Align drive shaft.
Center bearing must be located between two markings (arrow-C-).
^
Install mounting bolts and previously determined shims for drive shaft center bearing, and tighten.
^
Remove alignment fixture.
^
Install tunnel support.
^
Install heat shield over drive shaft.
^
Install exhaust system without tension.
^
Install cross brace.
Tightening torques