S8 Quattro Sedan V8-4.2L (AYS) (2002)
1 - Hex bolt
^
Replace each time after removing
Vehicle must be standing on ground when tightening
^
Tightening torque
^
M 16 bolt: 190 Nm (140 ft. lbs.) plus additional 180° turn.
2 - Boot for outer constant velocity joint
^
Check for tears and chafing
^
To equalize the pressure, briefly lift boot before tightening hose clamp Refer to Fig. 3
^
Different versions in rubber or Hytrel
3 - Hose clamp
^
Different versions in rubber or Hytrel for joint boot
^
Always replace
4 - Drive axle
5 - Hose clamp
6 - Joint piece
7 - Multipoint socket head bolt
^
M10 x 20; 70 Nm (52 ft. lbs.)
8 - Triple-roller star
^
The chamber arrow-faces drive axle splines.
^
Installation position, Refer to Triple-roller joint, disassembling and assembling.
9 - Circlip
^
Always replace
^
Insert in shaft groove
10 - Seal
11 - Cover